Description

Description

Precision CNC machined from solid billet 6061-T6 aluminum to fit perfectly and handle high torque and vibration. This bracket kit comes complete with stainless steel tensioning rods and chrome moly rod ends for high performance operation. All necessary hardware included. Powder coated to eliminate polishing in those hard to reach places. Matching serpentine pulleys are precision CNC machined from 6061-T6 aluminum. This is the same material we use for NASCAR pulleys! These pulleys will not fracture like common cast pulleys. High tensile strength means much longer wear. We go as far as hard coating the high wear areas to "65" Rockwell (harder than steel)! All pulleys have a maintenance-free clear powder coat.

Our High Water Flow Ratio Pulleys increase water flow and fan speed (Recommended for Daily Drivers). Our Performance Ratio Pulleys Increases horsepower by reducing accessory drag, 12-15 h.p. at rear wheels typical (Recommended for Race Cars Only).

Application:

Ford 289, 302, & 351 Windsor

Requirements :

1979-1993 Reverse Rotation Water Pump with Driver Side Lower Radiator Hose

Ford Racing M8501-G351 Standard Rotation Water Pump

90 Degree Thermostat Housing

4 Bolt Balancer

Water Pump Flange to Damper Face Measurement 3.25"

* Electric Fuel Pump Required for Kits Using Power-Steering

** If Using an Aftermarket Balancer, Kit May Require : Balancer Spacer

Kit Includes:

Alternator bracket, tensioners and hardware for Ford 1G Alternator
Crank pulley
Alternator pulley with fan and nose cover
Idler bracket with Idler and cover
Water Pump pulley with nose cover for 1979-1993 Reverse Rotation Water Pump with Driver Side Lower Radiator Hose or Ford Racing M8501-G351 Standard Rotation Water Pump

Power Steering Kit Includes: